Scratch And Sand Non Shrinkable Car Body Filler Lightweight Polyester

Easy To Fill Scratch And Sand Non-Shrinkable Car Body Filler

Description

• MJ-Coat Car Filler is a high quality lightweight polyester body filler designed for trade or handyman use in the filling of dents, cracks, holes or gaps.
• It is ideal for repairs to motor vehicles, boats, trailers, caravans, brickwork, concrete, guttering, furniture and hundreds of other repairs around the house.
• Its creamy texture makes it easy to apply with no drag and no sag even at high build levels.
• It is manufactured under vacuum to substantially reduce the incidence of pinholing; and the viscosity, gel and cure are strictly controlled to provide consistent quality.
• Car Filler exhibits minimal surface tack, easy sanding and good featheredging, and it provides excellent adhesion over mild steel, stainless steel, aluminium, fibreglass, wood, concrete, cement and fibro.

Substrates:

• Most metal surfaces (always check before proceeding, if uncertain)
• Polyester body filler
• Glass reinforced polyester (GRP & general types of fibreglass body parts)
• Sound existing surfaces, except for unstable surfaces such as thermoplastic acrylics, nitrocellulose or enamels
• All surfaces must be thoroughly sanded and cleaned with Concept Wax & Grease Remover prior to application.
• Ensure the surface is thoroughly dry beforeproceeding.

MIXING:

• For best results, bring filler and provided hardener to room temperature (minimum temperature 68ºF).
• Knead product in pouch and hardener tube before use.
• Place a 4” diameter puddle of filler on a clean mixing surface; we recommend a non-absorbent plastic mixing board.
• Add a ribbon of cream hardener from edge-to-edge across the center of the filler puddle (puddles larger than 4” will require additional hardener); or measure hardener at 2% by weight of filler – a 100:2 ratio. Mix thoroughly with a plastic spreader, using a folding motion, until uniform color is achieved.
• At room temperature (75ºF) approximate setting time is 3-5 minutes.

IMPORTANT:

FOR PROFESSIONAL USE ONLY.

Read full instructions before use.

This product contains hazardous materials and therefore appropriate personal protective equipment should always be used. Please refer to the label and consult the safety data sheet for full handling instructions and personal protection information. MJ-Coat disclaims any liability where the user does not wear the recommended personal protective equipment. The above data is for information only and may change without prior notice. It is the Buyers responsibility to ensure the suitability of the products for their own use and check the information is up to date.

The recommendation of use of our products and application in our technical data sheets are based on our knowledge and experience.  MJ-Coat is not responsible for the results obtained by others over whose methods we have no control and thereof MJ-Coat is not liable for consequential or incidental damages including loss of profits.