OEM Automotive Putty Filler Construction And Conductive Polyester Putty

Yellow Good Filling Quick Dry Non-Deformable Car Body Filler

MJ-Coat Polyester Putty

PRODUCTS

Construction and Conductive Polyester Putty. Hardener for the Polyester Putty.

PRODUCT DESCRIPTION

• High quality carbon fibre reinforced polyester putty for car repairs.
• It is recommended for filling large dents and holes in vehicles, caravans and trailers.

1. Exhibit superb adhesion to metal.
2. Large hardness with high elasticity.
3. Extremely short hardening time.
4. Very good sanding properties.

Color -grey.yellow.green .

MIXING:

• For best results, bring filler and provided hardener to room temperature (minimum temperature 68ºF).
• Knead product in pouch and hardener tube before use.
• Place a 4” diameter puddle of filler on a clean mixing surface; we recommend a non-absorbent plastic mixing board.
• Add a ribbon of cream hardener from edge-to-edge across the center of the filler puddle (puddles larger than 4” will require additional hardener); or measure hardener at 2% by weight of filler – a 100:2 ratio. Mix thoroughly with a plastic spreader, using a folding motion, until uniform color is achieved.
• At room temperature (75ºF) approximate setting time is 3-5 minutes.

DRYING/SANDING TIMES

• Allow the application of filler to cure 20 to 30 minutes.
• Sand with 80 grit sand paper and featheredge with 180 grit sandpaper or finer.
• Wait 1 hour before painting.
• Drying time depends on temperature and amount of hardener used.
• Optional: Apply a very thin layer of MJ-coat Glazing & Spot Putty to fill pinholes or small imperfections if necessary.