Paste State Car Body Filler High Adhesion Quick Dry Non Deformable

High Adhesion Easy To Scratch Quick Dry Non-Shrinkable Car Body Filler

Description:

• MJ-Coat car putty Filler, the latest product in our line of advance technology lightweight body fillers.
• MJ-Coat Super Smooth Filler contains both micro-perfecting surface technology to reduce the chance of pinholes as well as adhesion booster for maximum adhesion to auto body surfaces.
• MJ-Coat car putty Filler, is easy-to-spread and apply and levels well as a result of lower surface tension.
• With its super smooth application, your sanding times will be greatly reduced; less sanding = less time.
• With MJ Filler you can eliminate the glazing putty step of auto body repair.

DIRECTIONS OF USE

Use for filling and repair of minor bodywork up to ¼”, such as dents, dings, hail damage, and small holes.

SURFACE PREPARATION:

1. Clean surface. Remove all dirt, oil, grease and wax with a cleaning solvent such as #1240-1 Wax, Grease & Silicone Remover.

2. Make sure surface is dry before repairing.

3. Use 40-80 grit discs to featheredge paint for good mechanical adhesion.

MIXING:

• For best results, bring filler and provided hardener to room temperature (minimum temperature 68ºF).
• Knead product in pouch and hardener tube before use.
• Place a 4” diameter puddle of filler on a clean mixing surface; we recommend a non-absorbent plastic mixing board.
• Add a ribbon of cream hardener from edge-to-edge across the center of the filler puddle (puddles larger than 4” will require additional hardener); or measure hardener at 2% by weight of filler – a 100:2 ratio. Mix thoroughly with a plastic spreader, using a folding motion, until uniform color is achieved.
• At room temperature (75ºF) approximate setting time is 3-5 minutes.

DRYING/SANDING TIMES

• Allow the application of filler to cure 20 to 30 minutes.
• Sand with 80 grit sand paper and featheredge with 180 grit sandpaper or finer.
• Wait 1 hour before painting.
• Drying time depends on temperature and amount of hardener used.
• Optional: Apply a very thin layer of MJ-coat Glazing & Spot Putty to fill pinholes or small imperfections if necessary.