1L Car Body Filler Easy To Sand Polyester Putty Leveling High Efficiency

Easy-To-Sand Polyester Putty Leveling High Efficiency Car Body Filler

Description:

1. MJ-COAT PUTTY Polyester Finishing & Blending Putty is effortless to spread and self-levels to a smooth, easy-to-sand surface that is pinhole free – improving your cycle time.
2. The advanced easy-powder formula increases the sanding window. MJ-COAT PUTTY provides excellent results for that invisible repair every time whether over body filler, sand scratches, pinholes, aged OEM topcoats, steel, aluminum, galvanized and other zinc-coated metals, fiberglass and a wide variety of other substrates.

PRODUCT USES:

• Use for minor body work and surface imperfections (1/8” thick or less) such as sand scratches, chips, scratches and pinholes.
• Ideal for use as a finish coat over body filler.

TYPICAL SUBSTRATES:

• Steel.
•  Aluminum.
• Fiberglass.
• Body filler.
• Wood.
• 2K primers .
• Galvanized and other zinc-coated steel.
• MJ-COAT can be used for cosmetic repairs.
• For structural repairs prone to high degrees of stress and flexibility, use an car piant repair product.
• For flexible plastics use  Fiberglass body filler.

MIXING

1. Knead cream hardener tube thoroughly before using.
2. For a golf ball-size amount of filler, squeeze out 1+ 1/4-inch strip of hardener, or mix 3 inch diameter circle, 1/2-inch thick of filler to 3 inch strip of cream hardener.
3. Correct ratio is 2:100 by weight.
4. Mix thoroughly to uniform color on clean, nonporous surface.
5. Mix only small amounts that can be used within 3 to 4 minutes.
6. Do not add cream hardener in filler container

SURFACE PREPARATION:

1. Clean surface. Remove all dirt, oil, grease and wax with a cleaning solvent such as Grease & Silicone Remover.

2. Make sure surface is dry before repairing.

3. Use 80 – 180 grit disc to featheredge paint for good mechanical adhesion.

DRYING/SANDING TIMES

• Allow the application of filler to cure 20 to 30 minutes.
• Sand with 80 grit sand paper and featheredge with 180 grit sandpaper or finer.
• Wait 1 hour before painting.
• Drying time depends on temperature and amount of hardener used.
• Optional: Apply a very thin layer of MJ-coat Glazing & Spot Putty to fill pinholes or small imperfections if necessary.